START KIT - For adding counterweights to a lamp base

Start kit for adapting counterweights to a lamp base

The Start Kit is designed for restoring a floor lamp. You can modify it by adding, removing, or replacing accessories by clicking this link. This kit is NOT COMPATIBLE with every lamp. You must adapt the measurements and references to the dimensions of your lamp base.

Composition

Each lamp base is different, and installing counterweights depends on the measurements of each lamp.

• Counterweights: 3 stackable units with a diameter of 150mm
• Central hole: 10 mm
• Included accessories: threaded rods, nut, and metal bridge

All elements feature an unpolished brass finish, with a warm and timeless tone that suits both classic and contemporary interiors.

Procedure

To install counterweights, you must measure the inner diameter of your lamp base. Select the counterweight diameter you need. Depending on the height of the lamp base, you can add one or more counterweights. The metal bridge and threaded rods facilitate the exit of the electrical cable. To install the counterweights, it is necessary to cut the connection and subsequently add a new plug.

As this process can be complex, we recommend contacting our customer service for more detailed advice.

Compatibility and ceramic base requirements

These counterweights are compatible with floor lamps that have only one central tube. They are not suitable for lamps with two tubes.

Important note

Photograph of the approximate result. The lamp that can be assembled with these accessories will be the same or very similar to the one shown in the reference images. The characteristics, photographs, or technical specifications of the product may vary slightly depending on the manufacturer or production batch, without affecting its functionality, quality, or compliance with applicable safety standards.